Q. The low temperatures affected our citrus trees from last year. Most of my new growth is on the suckers. Should I remove them? Or just let the tree be?
A. If you look at the trunk of the tree you should see a
bend in the trunk or “dogleg” where the top was budded or grafted on to the
rootstock. I doubt if it is on its own roots which would mean you would see no
bend or dogleg.
Example of a "dogleg" where a fruit tree (in this case not citrus) was budded previously. |
Anything
coming from or below this bend should be removed and kept off. Whenever you see
any type of growth at all from these spots it should be removed. If you let
this growth develop it will rob growth from the part of the tree you want to
keep and eventually dwarf or kill the good part of the tree.
Next you
want to allow the lowest branches to develop from the trunk at a height you
want these branches to remain. The distance these lowest branches are now will
be the height they will be in ten years from now.
If these
are too low then move up the trunk to a place where you want the lowest limbs
to develop. Remove any of these unwanted lower limbs completely from the trunk
by cutting them as close to the trunk as possible.
You can do
this now if you want or you can wait until next January or February if there is
fruit on them. I am not sure which citrus you have but if it is lemon they
should probably be harvested in December.
Try to find
limbs to keep which are coming from the trunk going in different directions.
Hopefully you will find one limb going north, one south, one east and one west
(I think you get what I mean by going in different directions as this will give
the tree “balance” and reduce shading of itself).
On the
limbs coming from the trunk, remove shoots going straight up or straight down.
This leaves shoots that spread out in a fan (horizontally or laterally) but
remove shoots that are growing up or down. This allows for better light
penetration inside the tree and helps distribute fruit production throughout
the canopy rather than just on the perimeter. I hope this helps.
No comments:
Post a Comment